Suppose you have changes in new1 to the original lines 10-20,
and changes in new2 to the original lines 15-25, then the
changes to 10-25 conflict. But it is possible that the next
changes in new1 still overlap with this change to new2.
So, in the next iteration we have to look at the same change
to new2 again.
The old code tried to be a bit too clever. The new code is
shorter and more to the point: do not fiddle with the ranges
at all.
Also, xdl_append_merge() tries harder to combine conflicts.
This is necessary, because with the above simplification,
some conflicts would not be recognized as conflicts otherwise:
In the above scenario, it is possible that there is no other
change to new1. Absent the combine logic, the change in new2
would be recorded _again_, but as a non-conflict.
Signed-off-by: Johannes Schindelin <Johannes.Schindelin@gmx.de>
If one side's block (of changed lines) ends later than the other
side's block, the former should be tested against the next block
of the other side, not vice versa.
Signed-off-by: Johannes Schindelin <johannes.schindelin@gmx.de>
Signed-off-by: Junio C Hamano <junkio@cox.net>
The line range is i1 .. (i1 + chg1 - 1), not i1 .. (i1 + chg1).
Signed-off-by: Johannes Schindelin <johannes.schindelin@gmx.de>
Signed-off-by: Junio C Hamano <junkio@cox.net>
The callers would want to know if the resulting merge is clean;
do not discard that information away after calling xdl_do_merge().
Signed-off-by: Junio C Hamano <junkio@cox.net>
This new function implements the functionality of RCS merge, but
in-memory. It returns < 0 on error, otherwise the number of conflicts.
Finding the conflicting lines can be a very expensive task. You can
control the eagerness of this algorithm:
- a level value of 0 means that all overlapping changes are treated
as conflicts,
- a value of 1 means that if the overlapping changes are identical,
it is not treated as a conflict.
- If you set level to 2, overlapping changes will be analyzed, so that
almost identical changes will not result in huge conflicts. Rather,
only the conflicting lines will be shown inside conflict markers.
With each increasing level, the algorithm gets slower, but more accurate.
Note that the code for level 2 depends on the simple definition of
mmfile_t specific to git, and therefore it will be harder to port that
to LibXDiff.
Signed-off-by: Johannes Schindelin <Johannes.Schindelin@gmx.de>
Signed-off-by: Junio C Hamano <junkio@cox.net>
