As a general principle, we should not use "git diff" to validate the
results of what git command that is being tested has done. We would not
know if we are testing the command in question, or locating a bug in the
cute hack of "git diff --no-index".
Rather use test_cmp for that purpose.
Signed-off-by: Junio C Hamano <gitster@pobox.com>
This is meant to be used to keep --not and --all during revision parsing.
Signed-off-by: Pierre Habouzit <madcoder@debian.org>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
Originally, test_expect_failure was designed to be the opposite
of test_expect_success, but this was a bad decision. Most tests
run a series of commands that leads to the single command that
needs to be tested, like this:
test_expect_{success,failure} 'test title' '
setup1 &&
setup2 &&
setup3 &&
what is to be tested
'
And expecting a failure exit from the whole sequence misses the
point of writing tests. Your setup$N that are supposed to
succeed may have failed without even reaching what you are
trying to test. The only valid use of test_expect_failure is to
check a trivial single command that is expected to fail, which
is a minority in tests of Porcelain-ish commands.
This large-ish patch rewrites all uses of test_expect_failure to
use test_expect_success and rewrites the condition of what is
tested, like this:
test_expect_success 'test title' '
setup1 &&
setup2 &&
setup3 &&
! this command should fail
'
test_expect_failure is redefined to serve as a reminder that
that test *should* succeed but due to a known breakage in git it
currently does not pass. So if git-foo command should create a
file 'bar' but you discovered a bug that it doesn't, you can
write a test like this:
test_expect_failure 'git-foo should create bar' '
rm -f bar &&
git foo &&
test -f bar
'
This construct acts similar to test_expect_success, but instead
of reporting "ok/FAIL" like test_expect_success does, the
outcome is reported as "FIXED/still broken".
Signed-off-by: Junio C Hamano <gitster@pobox.com>
If options are aggregated, and that the whole token is an exact
prefix of a long option that is longer than 2 letters, reject
it. This is to prevent a common typo:
$ git commit -amend
to get interpreted as "commit all with message 'end'".
The typo check isn't performed if there is no aggregation,
because the stuck form is the recommended one. If we have `-o`
being a valid short option that takes an argument, and --option
a long one, then we _MUST_ accept -option as "'o' option with
argument 'ption'", which is our official recommended form.
Signed-off-by: Pierre Habouzit <madcoder@debian.org>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
When an option could be an ambiguous abbreviation of two options, the code
used to error out. Even if an exact match would have occured later.
Test and original patch by Pierre Habouzit.
Signed-off-by: Johannes Schindelin <Johannes.Schindelin@gmx.de>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
When there is an option "--amend", the option parser now recognizes
"--am" for that option, provided that there is no other option beginning
with "--am".
Signed-off-by: Johannes Schindelin <johannes.schindelin@gmx.de>
Signed-off-by: Shawn O. Pearce <spearce@spearce.org>
